How to install the camera slider ?

　　Sevenoak Carbon Fiber Track Camera Slider SK-TXS80 is a portable and extendable carbon fiber slider designed for both amateur and professional photographers/ video makers. It features a belt-drive system driven by an included flywheel. The flywheel attaches to the end of the slider, providing a handle for smooth and precise handcranked slides, even at slow speeds. It also serves as an inertial dampener that helps your camera stop smoothly for usable tracking shots and push-ins from start to finish of each take.The sliding plate features a 3/8” screw which is compatible with most tripods head, besides this, the sliding plate is also built with several extra 1/4” and 3/8” threaded holes which enables to you attach other accessories like LED lights, Microphone or monitor etc.

　　If the camera mounting platform is not able to be inserted onto the tubes, unscrew the two screws on the rotating plate as shown in figure 1. Rotate the plate clockwise to ensure the tubes can go through,then rotate the plate counter-clockwise till the wheels and the tubes are in proper position, tighten the screws.

　　Note: The rotating plate on camera mounting platform is adjustable, and it is designed to adjust the position of the bearings on the rotating plate.

　　2. Loosen the locking screws on one of the supporting feet and fixer, insert the carbon fiber tubes to the supporting feet and tube fixer as shown in below figure 4, tighten the fixer locking screws.
 

　　3. Loosen the locking screw on the other supporting feet and tube fixer, insert to the carton fiber tubes to the tube fixer as shown in figure 5, then tighten the locking screws.
 

　　4. Now loosen the feet locking screws, then unfold the feet and adjust them to a position as your desire, then tighten the screws to ensure the feet are fastend.
 

　　5. Install the belt:

　　5.1 Get two side of belt through one of the fixer (as shown in figure 8) and then one side of belt through the bottom of the camera mounting platform, fix the belt on the locking screw as shwon in figure 9.

　　5.2 Get the other side of the belt through another side of the suppprting feet and fixer as shown in figure 10.

　　5.3 Fix the belt onto the camera mounting plateform as shown in figure 11, tighten the screw to ensure the belt is secured.

　　6. Install the rolling plate Install the rolling bar onto the plate as shown in figure 12,tighten the rolling bar with the included Allen key.

　　7. Install the rolling plate onto the fixer as shown in figure 13,tighten the screw (figure 14) to ensure the rolling plate is fastened.

　　8. Install the camera onto the slider, it is ready to use now.We suggest to install a ball head (not included) onto the camera mounting platform first, then install the camera onto the ball head, it will enable you to adjust the camera angle conveniently.